User Manual
Table Of Contents
- Warranty
- Introduction
- Charging
- Connecting to a Host
- Scanning
- Transmitting Bar Code Data to Host
- Troubleshooting
- Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Power Supply
- Batteries
- Radio Frequency Interference Requirements- FCC
- Marking and European Economic Area (EEA)
- Japan (VCCI) - Voluntary Control Council for Interference
- Waste Electrical and Electronic Equipment (WEEE)
4 CS3000 Series
Charging
To charge the CS3000 series scanner, connect it
to a host PC via the USB host cable or charging
cradle. No power supply is necessary. Charge
time is approximately three hours for a fully
discharged battery.
Charging via USB Host Cable
1. Insert the mini-USB connector on the host
cable in the interface port on the scanner.
2. Connect the other end of the host cable to a
USB port on the host PC.