User Manual
Table Of Contents
- Warranty
- Introduction
- Charging
- Connecting to a Host
- Scanning
- Transmitting Bar Code Data to Host
- Troubleshooting
- Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Power Supply
- Batteries
- Radio Frequency Interference Requirements- FCC
- Marking and European Economic Area (EEA)
- Japan (VCCI) - Voluntary Control Council for Interference
- Waste Electrical and Electronic Equipment (WEEE)
Quick Reference Guide 19
US and Canada
Co-located statement
To comply with FCC RF exposure compliance requirement, the antenna
used for this transmitter must not be co-located or operating in
conjunction with any other transmitter/antenna except those already
approved in this filling.
Handheld Devices
To comply with FCC RF exposure requirements, this device must be
operated in the hand with a minimum separation distance of 20 cm or
more from a person's body. Other operating configurations should be
avoided.
Laser Devices
Complies with 21CFR1040.10 & 1040.11 except for
deviations pursuant to Laser Notice NO. 50, dated June
24, 2007 and IEC/EN 60825-1:2007 and/or IEC/EN
60825-1:2014.
The laser classification is marked on one of the labels on the device.
Class 1 Laser devices are not considered to be hazardous when used for
their intended purpose. The following statement is required to comply
with US and international regulations:
Caution: Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous laser light
exposure.
Scanner Labeling
CS3000 Labeling
ICES/NMB-003
CLASS B
N410
MIN-CS3000(B)
MADE IN CHINA
P/N:XXXXXX-XXXXXXXXXXX
(S)S/N:XXXXXXXXXXXXXXXXX MFD: 23SEP09
Mod: CS3000
5V 0.85A
CM-2