User`s guide

86 CPU32 Emulation
Chapter 5: Connecting and Configuring the Emulator
Configuring the Emulator
Trigger out configuration
To configure the Trigger In BNC (Emulation
Probe Only)
With an emulation module, this configuration item is always set to the
default setting and cannot be changed with a cf command. The
Intermodule window of the logic analysis system must be used instead.
Trigger in configuration
Value The Trigger Out BNC will Built-in command
fixhigh Always be high
cf trigout=fixhigh
fixlow Always be low
cf trigout=fixlow
monhigh Go high when the processor is
running in background (Default)
cf trigout=monhigh
monlow Go low when the processor is
running in background
cf trigout=monlow
Value Meaning Built-in command
off Inputs to the Break In BNC will be
ignored.
cf breakin=off
rising The emulation probe will cause a
break on a rising edge. (Default)
cf breakin=rising
falling The emulation probe will cause a
break on a falling edge.
cf breakin=falling