User`s guide

CPU32 Emulation 85
Chapter 5: Connecting and Configuring the Emulator
Configuring the Emulator
processor through the emulator can be recovered by applying the
configuration to the emulator with the target processor clock rate set
to a known good value.
To configure restriction to real-time runs
Real-time runs configuration
To configure the Trigger Out BNC (Emulation
Probe Only)
With an emulation module, this configuration item is always set to the
default setting and cannot be changed with a cf command. The
Intermodule window of the logic analysis system must be used instead.
Value Emulator configuration
Built-in
command
no Allows commands which break to the
monitor. Examples include commands
which display memory or registers.
(Default)
cf rrt=no
yes No commands are allowed which
break to the monitor, except “break,”
“reset,” “run,” or “step.”
cf rrt=yes