User`s guide

Contents
7
5
Connecting and Configuring the Emulator
59
Connecting and Configuring the Emulator 60
Using the Emulation Control Interface 61
To start the Emulation Control Interface from the main System window 62
To start the Emulation Control Interface from the Workspace window 63
To start the Emulation Control Interface from the Workspace window for an
emulation probe 64
Designing a Target System for the Emulator 65
Debug port connections 65
8-pin BDM port 67
10-pin BDM port 67
Target V
DD 67
CONFIG2 pin 68
Enabling BDM 68
To test the emulator 68
Connecting the Emulator to the Target System 69
To connect to a target system using a 10-pin debug port 70
To connect to a target system via an 8-pin debug port 71
To connect to a target system using an analysis probe 73
To verify communication between the emulator and target system 74
Configuring the Emulator 75
What can be configured 75
To configure using the Emulation Control Interface 76
To configure using the built-in commands 77
To configure using a debugger 78
To configure the processor type 79
To configure the processor clock speed (BDM communication speed) 80
To set the default clock rate if the processor clock rate is less than 8 MHz 81
Detailed information about processor clock rates 83
To configure restriction to real-time runs 85