User`s guide

78 CPU32 Emulation
Chapter 5: Connecting and Configuring the Emulator
Configuring the Emulator
To configure using a debugger
Because the HP emulator can be used with several third-party
debuggers, specific details for sending the configuration commands
from the debugger to the emulator cannot be given here. However, all
debuggers should provide a way of directly entering terminal mode
commands to the emulator. Ideally, you would create a file that
contains the modified configuration entries to be sent to the emulator
at the beginning of each debugger session.
See Also
Information about specific debuggers in Chapter 7, “Using the
Emulator with a Debugger,” beginning on page 103.
Your debugger manual.
Example
To see a complete list of configuration items, type help cf. This
command displays:
M>help cf
cf - display or set emulation configuration
cf - display current settings for all config items
cf <item> - display current setting for specified <item>
cf <item>=<value> - set new <value> for specified <item>
cf <item> <item>=<value> <item> - set and display can be combined
help cf <item> - display long help for specified <item>
--- VALID CONFIGURATION <item> NAMES ---
proc - Set type of CPU16/32 Processor
procck - Set Clock Speed of Processor
dprocck - Display Default Clock Speed of Processor
rrt - Enable or Disable Restriction to Real-Time Runs
breakin - Select BNC break input option
trigout - Select BNC trigger output option
M>