User`s guide

72 CPU32 Emulation

Chapter 5: Connecting and Configuring the Emulator

Connecting the Emulator to the Target System

4 Plug one end of the 10-pin cable into the target interface module.

5 Plug the other end of the 10-pin cable into the target system.

Orient the red wire toward pin 1 of the connector. Pins 1 and 2 of the

cable should be the ones which are not connected. Connect pin 3 of the

cable to pin 1 of the target connector.

CAUTION:

Be careful to orient the connector as shown below. If the connector is rotated,

your target system or the emulator may be damaged.

6 Turn on the power to the logic analysis system, then turn on the

power to the target system.