User`s guide

CPU32 Emulation 71
Chapter 5: Connecting and Configuring the Emulator
Connecting the Emulator to the Target System
CAUTION:
Be careful to orient the connector as shown below. If the connector is rotated,
your target system or the emulator may be damaged.
6
Turn on the power to the logic analysis system, then turn on the
power to the target system.
See Also
“Designing a Target System for the Emulator” on page 65.
To connect to a target system via an 8-pin
debug port
1
Remove power from the target system and the emulator.
2
Plug one end of the 50-pin cable into the emulator.
3
Plug the other end of the 50-pin cable into the target interface
module.