User`s guide

60 CPU32 Emulation
Chapter 5: Connecting and Configuring the Emulator
Connecting and Configuring the Emulator
Connecting and Configuring the Emulator
This chapter shows you how to connect the emulator to the target
system and how to configure the emulator and target.
Here is a summary of the steps for connecting and configuring the
emulator:
1
Make sure the target system is designed to work properly with
the emulator. (page 65)
2
Install the emulation module in your logic analysis system, if
necessary. (page 47)
3
Connect the emulator to your target system using the 50-pin
cable and the TIM or an analysis probe. (page 69)
4
Update the firmware of the emulator, if necessary. (page 147)
5
Verify communication between the emulator and the target.
(page 74)
6
Configure the emulator. (page 75)
7
Test the connection between the emulator and the target. (page
87)
8
Connect a debugger to the emulator, if applicable. (page 103.)
See Also
Chapter 7, “Using the Emulator with a Debugger,” beginning on page
103 for information on configuration with a debugger, and on
configuring LAN port numbers.