User`s guide

46 CPU32 Emulation
Chapter 2: Connecting the Emulation Probe to a LAN
Setting Up a Serial Connection
To verify serial communications
1 Start a terminal emulator program on the host computer.
If you are using a PC, the Terminal application in Microsoft Windows
will work fine.
If you are using a UNIX workstation, you can use a terminal emulator
such as cu or kermit.
2 Plug the power cord into the emulation probe.
When the emulation probe powers up, it sends a message (similar to
the one that follows) to the serial port and then displays a prompt:
Copyright (c) Hewlett-Packard Co. 1987
All Rights Reserved. Reproduction, adaptation, or translation without
prior written permission is prohibited, except as allowed under
copyright laws.
HPE3499A Series Emulation System
Version: A.07.53 01Mar98
Location: Generics
HPE3490A Motorola CPU16/32 BDM Emulator
Version: A.02.05 01Mar98
R>
The version numbers may be different for your emulation probe.
3 Press the Return or Enter key a few times.
You should see a prompt such as "p>", "R>", or "?>".
For information about the commands you can use, enter ? or help at
the prompt.
See Also
“Troubleshooting the Emulator” on page 160.