User`s guide

CPU32 Emulation 43
Chapter 2: Connecting the Emulation Probe to a LAN
Setting Up a Serial Connection
interface uses the DSR:CTS/RTS lines for flow control. Set S5 to
OFF (HW HANDSHAKE OFF) if your serial interface uses
software flow control (XON/XOFF).
If your serial interface supports hardware handshaking, you should use
it (set switch S5 to ON). Hardware handshaking will make the serial
connection much more reliable.
4 Set switches S6-S8 for the baud rate you will use. These switch
settings are listed on the bottom of the emulation probe.
The higher baud rates may not work reliably with all hosts and user
interfaces. Make sure the baud rate you choose is supported by your
host and user interface.
Example
To use a baud rate of 9600 baud, set the switches as follows: