User`s guide

CPU32 Emulation 37
Chapter 2: Connecting the Emulation Probe to a LAN
Connecting the Emulation Probe to a LAN
See Also
Page 172, if you have problems verifying LAN communication.
To configure LAN parameters using BOOTP
Use this method only on a workstation which is running bootpd, the
BOOTP daemon.
1
Make sure that BOOTP is enabled on your host computer.
If the following commands yield the results shown below, the BOOTP
protocol is enabled:
$ grep bootp /etc/services
bootps 67/udp
bootpc 68/udp
$ grep bootp /etc/inetd.conf
bootps dgram udp wait root /etc/bootpd bootpd
If the commands did not yield the results shown, you must either add
BOOTP support to your workstation or use a different method to
configure the emulation probe LAN parameters.
Example
To assign an IP address of 192.6.94.2 to the emulation probe, enter
the following command:
R>lan -i 192.6.94.2
Now, cycle power on the emulation probe so that the new address
will take effect.