User`s guide

36 CPU32 Emulation
Chapter 2: Connecting the Emulation Probe to a LAN
Connecting the Emulation Probe to a LAN
This connection can be made by using either the 10BASE-T connector
or the 10BASE2 (BNC) connector on the emulation probe. Do not use
both connectors at the same time.
7
Set the configuration switches to indicate the type of connection
that is to be made.
Switch S1 must be set to OFF, indicating that a LAN connection is
being made.
Switch S5 should be ON if you are connecting to the BNC connector:
Switch S5 should be OFF if you are connecting to the 10BASE-T
connector:
Set all other switches to ON.
8
Connect the power cord to the emulation probe.
9
Verify your emulation probe is now active and on the network.
See “To verify LAN communications” on page 41.
Once you have set a valid IP address, you can use the telnet utility to
connect to the emulation probe, and use the lan command to change
LAN parameters.