User`s guide

20 CPU32 Emulation
Chapter 1: Overview
Emulation Probe
Minimum equipment required
The following equipment is required to use the emulation probe:
• A method for connecting the emulator to the target system. You can use an
HP analysis probe or you can design a debug port connector on the target
system. The target system must meet the criteria on page 65.
• A host computer, such as a PC or workstation. You can also connect the
emulation probe to an HP 16600A or HP 16700A logic analysis system.
• A LAN (local area network) to connect the emulation probe to the host
computer.
• A user interface on the host computer, such as a high-level source
debugger or the logic analysis system’s Emulation Control Interface.
To connect the emulation probe to a power
source
The emulation probe does not have an On/Off switch. To turn the
emulation probe on or off, plug or unplug it from the power supply.
The emulation probe is shipped from the factory with a power supply
and cord appropriate for your country. If the cord you received is not
appropriate for your electrical power outlet type, contact your Hewlett-
Packard sales and service office.
WARNING:
Use only the supplied HP power supply and cord. Failure to use the proper
power supply could result in electric shock.
CAUTION:
Use only the supplied HP power supply and cord. Failure to use the proper
power supply could result in equipment damage.