User`s guide

CPU32 Emulation 167
Chapter 11: Troubleshooting the Emulator
Emulator Built-in Commands
To use the built-in commands
Here are a few commonly used built-in commands:
Useful built-in commands
b Break—go into the background monitor state
cf Configuration—read or write configuration options
help Help—display online help for built-in commands
init Initialize—
init -c
re-initializes everything in the emulator
except for the LAN software;
init -p
is the equivalent of
cycling power (it will break LAN connections)
lan configure LAN address (emulation probes only)
m Memory—read or write memory
pp load Load EMSIM values into preprocessor
reg Register—read or write a register
r Run—start running user code
rep Repeat—repeat a command or group of commands
rst Reset—reset the target processor (the emulator will wait for you
to press the target’s RESET button)
s Step—do a low-level single step
sync diff Compare EMSIM with SIM registers
sync emsim Copy EMSIM to SIM registers
sync sim Copy SIM to EMSIM registers
ver Version—display the product number and firmware version of the
emulator