User`s guide

166 CPU32 Emulation
Chapter 11: Troubleshooting the Emulator
Emulator Built-in Commands
If the LAN name of the logic analysis system is “test2” and you have
only one emulation module installed, the command might look like this:
telnet test2 6472
4
If you do not see a prompt, press the
<Return>
key a few times.
To exit from this telnet session, type
<CTRL>D
at the prompt.
To telnet to the emulation probe
You can establish a telnet connection to the emulation probe if:
• A host computer and the probe are both connected to a local-area network
(LAN), and
• The host computer has the telnet program (often part of the operating
system or an internet software package).
To establish a telnet connection:
1
Find out the LAN address or LAN name of the emulation probe.
2
Start the telnet program.
If the LAN name of the emulation probe is “test2”, the command might
look like this:
telnet test2
3
If you do not see a prompt, press the
<Return>
key a few times.
To exit from this telnet session, type
<CTRL>D
at the prompt.