User`s guide

12
Contents
Emulation Module Status Lights 162
Emulation Probe Status Lights 163
Emulation Probe Status Lights 164
Emulator Built-in Commands 165
To telnet to the emulation module 165
To telnet to the emulation probe 166
To use the built-in commands 167
Problems with the BDM Connection 169
If a user interface behaves erratically 169
Problems with Configuration 170
If you have problems displaying some registers 170
If you have problems initializing some registers 170
Problems with the Target System 171
If boot area accesses fail 171
If the target system does not run 171
Problems with the LAN Interface (Emulation Module Only) 172
If LAN communication does not work 172
If it takes a long time to connect to the network 172
Problems with the Emulation Module 174
To run the built-in performance verification test using the logic analysis system
(Emulation Module Only) 174
To run complete performance verification tests using a telnet connection (Em-
ulation Module Only) 175
If a performance verification test fails 176
Problems with the LAN Interface (Emulation Probe Only) 177
If you cannot verify LAN communication 177
If you have LAN connection problems 178
If the "POL" LED is lit 179
If it takes a long time to connect to the network 179