User`s guide

CPU32 Emulation 107

Chapter 7: Using the Emulator with a Debugger

Setting up Debugger Software

The instructions in this manual assume that your PC or workstation is

already connected to the LAN, and that you have already installed the

debugger software according to the debugger vendor's documentation.

To use your debugger with the emulator, follow these general steps:

• Connect the emulator to your target system (see page 69).

• Connect the emulator or logic analysis system to the LAN (page 108).

• Export the logic analysis system's display to your PC or workstation

(page 112).

• Configure the emulator (page 75).

• Begin using your debugger.

If you use the Emulation Control Interface to configure the emulator,

remember to end the Emulation Control Interface session before you

start the debugger.

CAUTION:

Do not use the Emulation Control Interface at the same time as a debugger.

The Emulation Control Interface and debuggers do not keep track of

commands issued by other tools. If you use both at the same time, the tools

may display incorrect information about the state of the processor, possibly

resulting in lost data.