User`s guide

Typical setups using the preprocessor and
processor probe together
The illustrations in this section show typical equipment setups. The
setup you choose will depend on the type of development or test you
are performing (hardware or software), and the type of logic analyzer
you are using.
The preprocessor interface supplies signals from the target
microcontroller to the logic analyzer. A configuration file sets up the
logic analyzer to properly interpret these signals.
The preprocessor probe allows you to load program code and run it on
the target system.
Hardware Designer’s Solution using a Logic Analyzer, Preprocessor, and Processor Probe
E2480A Motorola CPU32 Preprocessor Interface 1-7