User manual
Table Of Contents
- Chapter 1: CPEo 450 User Guide
- Chapter 2: Installation
- Chapter 3: Configuration
- Chapter 4: Basic Configuration
- Personalize Menu
- Password Tab
- Device Time Tab
- Device Name Tab
- Restore Factory Settings Tab
- Internet Menu
- WiMAX Security Tab
- Internet Protocol Tab
- Firewall Tab
- Dynamic DNS Tab
- Status Menu
- Network Tab
- Telephony Tab
- Telephony Menu
- Account Tab
- Ring Tone Tab
- Caller ID Tab
- Call Forwarding Tab
- Voice Mail Tab
- Special Number Tab
- Chapter 5: Advanced Configuration
- Chapter 6: Configuring TCP/IP
- Chapter 7: Troubleshooting
- Chapter 8: Important Safety and Legal Information
- This Product complies with the following RF energy exposure standards and guidelines:
- RF Exposure Compliance and Control Guidelines and Operating Instructions
- FCC Regulatory Information
- Industry Canada Statement
- IC Radiation Exposure Statement:
- EU Declaration of Conformity
- Caring for the Environment
- Disposal of Motorola Equipment in EU Countries
- Disposal of Motorola Networks Equipment in Non-EU countries
- CMM Disclosure
- Copyrights and Trademarks
- Copyrights
- Usage and Disclosure Restrictions
CPEo 450 User Guide 1
Table 1-1 LED Indicator Interface
Item Description
Power Status The LEDs are:
• On - power to the CPE is on.
• Off - power to the CPE is off.
Initializing Status The center LED flashes when the CPE is initializing.
Signal Strength
• If all LEDs on the bar are lit, full signal is being
received.
• If all LEDs are off, the CPE is unplugged.
• LEDs will display a chase pattern when the device
is attempting to locate and connect to the
network.
There is no reset button on this CPE unit. If you want to reset the CPE,
pull out the power cord and plug it in again.
If all five WiMAX Signal Strength LEDs are blinking, then a software
upgrade is in progress. Do NOT remove power to the CPE.
Bottom Panel
The bottom panel of the units contains a VoIP port, and an Ethernet port.
68P09306A78-A 1-3
FEB 2010