Technical information

Creating and Managing Network Profiles
5. If you are configuring a profile for a closed network, check
this is a
non-broadcast network.
6. If the network whose profile you are configuring does not use WEP
or
WPA
encryption, no further security configuration is necessary, the
Enable data encryption box should remain unchecked and no further
configuration is necessary on
this page.
7. If the network doe
s use WEP or WPA encryption, check the Enable
da
ta encryption box and configure the WiFi data encryption settings
(see Ena
bling WiFi Data Encryption for instructions).
8. Click Next. The General page appears.
9. Configure the settings on the General page
and then click Finish.
Creating an Ethernet Network Profile
Follow these steps to create an Ethernet Network Profile:
1. Click the
Profiles button in the main window of the Motorola
Connectio
n Manager software. The Network Profiles window will now
be displayed.
2. Click on
the Ethernet heading in the list of profiles on the left side of
the windo
w.
3. Click the
Add button. The Ethernet page of the Add Profile Wizard
appears.
4. In the fields provided, e
nter the criteria that the Motorola Connection
Manager should use when attempting to match this profile to Ethernet
networks that you connect to. You must enter a value in at least one
of these fields (it does not matter which). Additional fields are
optional.
5. Click Next to continue to the IP Properties page.
6. The default
selections on the IP Properties page are correct for most
networks. If, however, this particular network requires specific IP
address and/or DNS server settings, you can specify them here.
7. Click Next. The General page appears.
USBw 100
32
FEB 2009