user manual

5PPCBug

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)

Notes

You may enter command names in either uppercase or lowercase

characters.

Some diagnostics depend on restart defaults that are set up only in a

particular restart mode. Refer to the documentation on a particular

diagnostic for the correct mode.

** PCI devices that are detected will be tested.

* Represent non-PCI devices that depend on the VPD SROM to determine if a

device is expected to be present. These devices are not located on the

PrPMC800/800ET, but could reside on a carrier board.

ISABRDGE** ISA Bridge Tests (DIR)

KBD8730x* Keyboard/Mouse Controller Tests* (DIR)

L2CACHE Level 2 Cache Tests (DIR)

LA Loop Always Mode

LC Loop Continuous Mode

LE Loop on Error Mode

LF Line Feed Mode

LN Loop Non-Verbose Mode

MASK Self Test Mask

MPIC Self Test Mask

NCR** NCR 53C8xx SCSI-2 I/O Processor Tests (DIR)

NV Non-Verbose Mode

PAR8730x* Parallel Interface (PC8730x) Test* (DIR)

PCI BUS PCI/PMC Generic Tests (DIR)

PHB PCI Host Bridge (Harrier) Tests (DIR)

QST Quick Self Test (DIR)

RAM Random Access Memory Tests (DIR)

RTC Real Time Clock Timekeeping (DIR)

SCC Serial Communications Controller (Z85C230) Tests (DIR)

SE Stop on Error Mode

ST Self Test (DIR)

UART Serial Input/Output Tests (DIR)

VGA54xx** VGA Controller (GD54xx) Tests

VME3** VME3 (Universe) Tests (DIR)

Z8536* Z8536 Counter/Timer Input/Output Tests* (DIR)

ZE Zero Errors

ZP Zero Pass Count

Table 5-2. Diagnostic Test Groups (continued)

Test Group Description