user manual

5PPCBug
PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)
43
Debugger Commands
The individual debugger commands are listed in the following table. The commands are
described in detail in the PPCBug Firmware Package User’s Manual.
Note
You can list all the available debugger commands by entering the Help (HE)
command alone. You can view the syntax for a particular command by entering
HE and the command mnemonic, as listed below.
Table 5-1. Debugger Commands
Command Description
AS One Line Assembler
BC Block of Memory Compare
BF Block of Memory Fill
BI Block of Memory Initialize
BM Block of Memory Move
BR Breakpoint Insert
NOBR Breakpoint Delete
BS Block of Memory Search
BV Block of Memory Verify
CACHE Modify Cache State
CM Concurrent Mode
NOCM No Concurrent Mode
CNFG Configure Board Information Block
CS Checksum
CSAR PCI Configuration Space READ Access
CSAW PCI Configuration Space WRITE Access
DC Data Conversion
DS One Line Disassembler
DU Dump S-Records
ECHO Echo String
ENV Set Environment
FORK Fork Idle MPU at Address
FORKWR Fork Idle MPU with Registers
GD Go Direct (Ignore Breakpoints)
GEVBOOT Global Environment Variable Boot
GEVDEL Global Environment Variable Delete
GEVDUMP Global Environment Variable(s) Dump
GEVEDIT Global Environment Variable Edit