user manual

PrPMC800/800ET Processor PMC Module Installation and Use (PrPMC800A/IH5)
xv
About This Manual
PrPMC800/800ET Processor PMC Module Installation and Use provides information for
installation and configuration of the PrPMC800/800ET, including jumper settings and
installation procedures. It also includes descriptions of various components’ functions,
connector pinout information, and a general description of the PPCBug firmware used with the
board.
Information in this manual applies to Motorola boards that are compatible with the PowerPC
™
instruction set architecture and that use PPCBug as their resident debugger program. The
majority of these boards, including most Processor PMC, VME, CompactPCI
®
and ATX form
factors, are equipped with PPCBug.
This document is limited to the installation and use instructions. For programming information,
refer to the Harrier ASIC Programmer’s Reference Guide and the PrPMC800/800ET Processor
PMC Module Programmer’s Reference Guide.
The following table lists the various model numbers and configurations for the
PrPMC800/800ET. Note that some of the models listed below qualify as Class B devices. If you
require a Class B device, contact your Motorola sales representative for specific models and
configurations that meet those requirements.
Table 2-1. PrPMC800/800ET Models/Configurations
Model Number
PrPMC800
Processor /
Speed
L2
Cache
Memory Ethernet PCI Bus
Speed
PrPMC800-5251 MPC750 Class/
450 MHz
1MB 128MB Front 33 MHz
PrPMC800-5261 MPC750 Class/
450 MHz
1MB 256MB Front 33 MHz
PrPMC800-5271 MPC750 Class/
450 MHz
1MB 512MB Front 33 MHz
PrPMC800-1261 MPC7410/
450 MHz
2MB 256MB Front 33 MHz
PrPMC800-1271 MPC7410/
450 MHz
2MB 512MB Front 33 MHz
PrPMC800-5259 MPC750 Class/
450 MHz
1MB 128MB Rear 33 MHz
PrPMC800-5269 MPC750 Class/
450 MHz
1MB 256MB Rear 33 MHz
* Industrial temperature models
For RoHS compliant models of these boards, please contact your local Motorola sales
representative.