user manual

MVME3100 Installation and Use (V3100A/IH1)
xv
About This Manual
The MVME3100 Single-Board Computer Installation and Use manual provides the information
you will need to install and configure your MVME3100 single-board computer and MVME721
rear transition module (RTM). It provides specific preparation and installation information, and
data applicable to the board.
As of the printing date of this manual, the MVME3100 supports the models listed below.
Overview of Contents
This manual is divided into the following chapters and appendices:
Chapter 1, Hardware Preparation and Installation, provides MVME3100 board preparation and
installation instructions, as well as ESD precautionary notes.
Chapter 2, Startup and Operation, provides the power-up procedure and identifies the switches
and indicators on the MVMEM3100.
Chapter 3, MOTLoad Firmware, describes the basic features of the MOTLoad firmware
product.
Chapter 4, Functional Description, describes the MVME3100 and the MVME721 RTM on a
block diagram level.
Chapter 5, Pin Assignments, provides pin assignments for various headers and connectors on
the MMVE3100 single-board computer.
Appendix A, Specifications, provides power requirements and environmental specifications.
Appendix B, Related Documentation, provides a listing of related Motorola manuals, vendor
documentation, and industry specifications.
Model Number Description
MVME3100-1152 677 MHz MPC8540 PowerQUICC III™ integrated processor,
256MB DDR SDRAM, 64MB flash, Gigabit Ethernet, SATA, IEEE
handles
MVME3100-1263 833 MHz MPC8540 PowerQUICC III integrated processor, 512MB
DDR SDRAM, 128MB flash, Gigabit Ethernet, SATA, USB, PCI
expansion connector, IEEE handles
MVME721-101 Rear Transition Module, direct connect, 75mm, PIM socket for
PMC-1 I/O, four serial, 10/100/1000 Enet, 10/100 Enet