user manual

Index
IN-14
I
N
D
E
X
move files between machines on differ-
ent networks 4-20
MPAR (Multiprocessor Access Register)
4-22
MPCR (Multiprocessor Control Register)
method 4-21
status codes 4-22
MPU clock speed calculation 4-12
MPU register CR20 5-11
multiple module cage configuration 3-28
Multiprocessor Address Register
(MPAR) 4-22
Multiprocessor Control Register (MPCR)
4-21
method 4-21
multiprocessor support 4-21
MVME187 2-1, C-1
block diagram 2-7
specifications 2-6
MVME187Bug debugging package
see also 187Bug and debug monitor
1-3, 3-14
MVME320 - Winchester/Floppy Con-
troller B-1
MVME323 - ESDI Winchester Controller
B-1, B-2
MVME327A - SCSI Controller B-1, B-3
MVME328 - SCSI Controller B-1, B-3
MVME350 - Streaming Tape Controller
B-1, B-4
MVME374 C-2
MVME376 C-1
MVME712-12 2-8, 3-17
MVME712-13 2-8, 3-17
MVME712A 2-8, 3-17
MVME712AM 2-8, 3-17
MVME712B 2-8, 3-17
MVME712M 2-8, 3-11, 3-17
MVME712X 2-8, 3-17
N
negation 1-3
network
controller data C-1
controller modules supported C-1
I/O error codes 4-21
I/O support 4-19
identify 4-19
network (local Ethernet interface) as a
boot device 4-19
network boot 4-8
control module 4-20
firmware 4-19
no display D-1
normal address range 2-24
numeric value 5-4
NVRAM (Non-Volatile RAM)
checksum error 4-12
low battery condition 4-12
O
object code 5-8
offset registers 5-7
onboard
DRAM 2-15
memory 2-2
selftest D-5
operating environment 5-10
operation parameters of the hardware
A-1
operational parameters A-3
operator precedence 5-5
option field 5-3
option modification 3-5
optional SRAM battery backup 2-14
overview of M88000 firmware 4-1
overview of startup procedure 3-2
P
P1 2-7
P2 2-7
P2 adapter board 2-7, 3-20, 3-29
packed decimal number 5-14
parallel (printer) port 2-3