user manual

D-3
D
III. Debug
prompt
187-Bug>
does not appear
at powerup, and
the board does
not auto boot.
A. Debugger
EPROM may be
missing.
1. Disconnect all power from your system.
2. Check that the proper debugger EPROM is
installed per this manual.
3. Reconnect power.
!
Caution
Performing the next
step will change some
parameters that may
affect your system
operation.
4. Restart the system by Òdouble-button resetÓ:
press the
RESET and ABORT switches at the same
time; release RESET Þrst, wait Þve seconds, then
release ABORT.
5. If the debug prompt appears, go to step IV or step
V, as indicated. If the debug prompt does not
appear, go to step VI.
B. The board
may need to be
reset.
Table D-1. Troubleshooting Steps (Continued)
Condition
Possible
Problem
Try This: