user manual

Hardware Preparation and Installation
2-8 MVME162 Embedded Controller Installation Guide
2
General Purpose Readable Jumpers Header (J22)
Header J22 provides eight readable jumpers. These jumpers are read as a
register (at $FFF4202D) in the MCchip LCSR (local control/status register).
The bit values are read as a zero when the jumper is installed and as a one
when the jumper is removed.
If the MVME162BUG firmware is installed, four jumpers are user-definable
(pins 1-2, 3-4, 5-6, 7-8). If the MVME162BUG firmware is not installed, seven
jumpers are user-definable (pins 1-2, 3- 4, 5-6, 7-8, 11-12, 13-14, 15-16).
Note
Pins 9-10 (GPIO3) are reserved to select either the Flash
memory map (jumper installed) or the EPROM memory
map (jumper removed). They are not user-definable.
The MVME162 is shipped from the factory with J22 set to all zeros (jumpers on
all pins).
J22
15
GPIO7
GPIO6
GPIO5
GPIO1
GPIO4
GPIO3
GPIO2
12
16GPIO0
EPROMs Selected (factory configuration)
USER-DEFINABLE
USER-DEFINABLE
USER-DEFINABLE
REFER TO 162BUG MANUAL
USER-DEFINABLE
IN=FLASH; OUT=EPROM
REFER TO 162BUG MANUAL
REFER TO 162BUG MANUAL
162BUG INSTALLED
USER-DEFINABLE
USER-DEFINABLE
USER-DEFINABLE
USER-DEFINABLE
USER-DEFINABLE
IN=FLASH; OUT=EPROM
USER-DEFINABLE
USER-DEFINABLE
USER CODE INSTALLED
910