user manual

Hardware Preparation and Installation

2-4 MVME162 Embedded Controller Installation Guide

Figure 2-2. Serial Interface Module, Connector Side

Removal of Existing SIM

1. Each serial interface module is retained by two 4-40 x

/16 ” Phillips-head

screws in opposite corners. Remove the two screws and store them in a

safe place for later use.

2. Grasp opposite sides of the SIM and gently lift straight up.

Caution

Avoid lifting the SIM by one side only, as the connector can

be damaged on the SIM or the main board.

3. Place the SIM in a static-safe container for possible reuse.

Table 2-1. Serial Interface Module Part Numbers

EIA

Standard

Configuration Part Number

Model

Number

EIA-232-D DTE 01-W3846B SIM05

DCE 01-W3865B SIM06

EIA-530 DTE 01-W3868B SIM07

DCE 01-W3867B SIM08

10922.00 9403 (2-2)

SECONDARY SIDE

39 1

40 2