user manual

Index
IN-2 MVME162 Embedded Controller Installation Guide
I
N
D
E
X
baud rates 1-15, 3-5
BBRAM (Battery Backed Up RAM) (see
MK48T08 and NVRAM) 1-14
BG (bus grant) 2-10
BH (Bootstrap and Halt) 3-14
binary number 1-8
block diagram 1-9
block size, logical 3-13
blocks versus sectors 3-13
BO (Bootstrap Operating System) 3-14
Board Information Block (BIB) A-1
board level hardware description 1-1
Board Mode, 162Bug 3-4
boldface strings 4-2
BOOTP protocol module 3-18
Bootstrap and Halt (BH) 3-14
Bootstrap Operating System) 3-14
Bootstrap Protocol (BOOTP) 3-18
braces 4-2
break 3-9
BREAK key 3-9
burst transfers 1-11
bus grant (BG) 2-10
byte 1-8
C
C programming language 3-3
cable(s) 2-11
cache 1-11
calling system utilities from user
programs 4-9
CCS (SCSI Common Command Set) B-2
character input/output 4-9
checksum A-3
CISC Embedded Controller(s) B-1
Clear To Send (CTS) 3-5
clock chip 1-14
clock select header (J12) 2-6
clock speed, MPU 3-10
clock sync/async select jumprs 2-6
CLUN (controller LUN) B-1, C-1
CNFG command A-1
command identifier 4-1
command line, debugger 4-1
command set (see 162Bug debugger
command set) 4-20
commands, debug 4-20
configuration, controllers/devices 3-16
configuration, default disk/tape
controller B-2
configuration, hardware 3-3
Configure (CNFG) and Environment
(ENV) commands A-1
configure BIB (Board Information Block)
A-1
configure debug parameters A-3
configuring
base address of Industry Packs A-13
Industry Packs A-13
VMEbus interface A-8
connection diagrams, MVME712X 2-13
connector P2 4-8
connectors 1-1, 1-20, 2-9
console port 4-8
control bit 1-8
control/key commands 3-11
controller B-1
controller LUN (CLUN) B-1
count 4-2
creating vector table 4-13
CTS (Clear To Send) 3-5
D
data bus structure 1-11
data circuit-terminating equipment
(DCE) 1-15
data terminal equipment (DTE) 1-15
DCE (data circuit-terminating
equipment) 1-15
debug monitor (see 162Bug and
MVME162Bug) 2-2
debug port 4-8
debugger address parameter formats 4-5
debugger commands 4-20