user manual

MVME162IG/D2IN-1
Index
When using this index, keep in mind that a page number indicates only where
referenced material begins. It may extend to the page or pages following the page
referenced.
Symbols
+12 Vdc power 2-12
+12Vdc power 1-10
+5 Vdc power 2-12
Numerics
162Bug
address 3-10
command line 4-1
command set 4-20
debugger command set 4-20
debugger package 3-1
disk/tape data B-1
floating point support 4-17
generalized exception handler 4-15
implementation of 3-3
installation 3-3
network controller data C-1
offset registers 4-6
port numbers 4-8
prompt 3-6
stack 3-11
using the debugger 4-1
vector table and workspace 4-10
vector tables 4-10
162Bug (see debug monitor and
MVME162Bug) 2-2, 4-1
27C040 PROM 3-3
28F020 Flash 3-3
5-1/4 DS/DD 96 TPI floppy drive B-2
53C710 (SCSI Controller) 1-18
82596CA (see Ethernet and LAN) 1-17,
3-17
A
ABORT switch 1-10, 3-9
adapter board (see P2 adapter board) 1-1
address 4-2
address as a parameter 4-4
address formats 4-4
address, DRAM 2-11
address, Flash/PROM 3-10
addresses in debug command lines 4-4
arbitration priority 1-20
arguments 4-1
arithmetic operators 4-3
ASCII string 4-2
ASIC (Application-Specific Integrated
Circuits) (see MCchip and
VMEchip2) 1-2
assembler/disassembler 4-9
assertion 1-8
autoboot 3-6
B
backplane connectors P1 and P2 2-11
backplane jumpers 2-10
Backus-Naur 4-2
base address of IndustryPacks A-13
base and top addresses 4-6
base identifier 4-3
Battery Backed Up RAM (BBRAM) and
Clock (see MK48T08 and
NVRAM) 1-14, A-3
battery backup function 1-12
battery backup select jumpers 2-7
battery care 1-13