user manual

Configure and Environment Commands
A-10 MVME162 Embedded Controller Installation Guide
A
Master Starting Address #1 02000000 Base address of the VMEbus
resource that is accessible from
the local bus. Default is the end
of calculated local memory,
unless memory is less than
16MB, then this register will
always be set to 01000000.
Master Ending Address #1 EFFFFFFF Ending address of the VMEbus
resource that is accessible from
the local bus. Default is the end
of calculated memory.
Master Control #1 0D Defines the access characteristics
for the address space defined
with this master address
decoder. Default is $0D.
Master Enable #2 [Y/N] N Do not set up and enable the
Master Address Decoder #2.
Master Starting Address #2 00000000 Base address of the VMEbus
resource that is accessible from
the local bus. Default is
$00000000.
Master Ending Address #2 00000000 Ending address of the VMEbus
resource that is accessible from
the local bus. Default is
$00000000.
Master Control #2 00 Defines the access characteristics
for the address space defined
with this master address
decoder. Default is $00.
Master Enable #3 [Y/N] Y Yes, set up and enable the Master
Address Decoder #3. This is the
default if the board contains less
than 16MB of calculated RAM.
Do not set up and enable the
Master Address Decoder #3.
This is the default for boards
containing at least 16MB of
calculated RAM.
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options Default Meaning of Default