user manual

Set Environment to Bug/Operating System
MVME162IG/D2 A-9
A
Slave Ending Address #1 000FFFFF Ending address of the local
resource that is accessible by the
VMEbus. Default is the end of
calculated memory.
Slave Address Translation Address #1 00000000 This register will allow the
VMEbus address and the local
address to be different. The
value in this register is the base
address of local resource that is
associated with the starting and
ending address selection from
the previous questions. Default
is 0.
Slave Address Translation Select #1 00000000 This register defines which bits
of the address are significant. A
logical one "1" indicates
significant address bits, logical
zero "0" is non-significant.
Default is 0.
Slave Control #1 03FF Defines the access restriction for
the address space defined with
this slave address decoder.
Default is $03FF.
Slave Enable #2 [Y/N] N Do not set up and enable the
Slave Address Decoder #2.
Slave Starting Address #2 00000000 Base address of the local
resource that is accessible by the
VMEbus. Default is 0.
Slave Ending Address #2 00000000 Ending address of the local
resource that is accessible by the
VMEbus. Default is 0.
Slave Address Translation Address #2 00000000 Works the same as Slave
Address Translation Address #1.
Default is 0.
Slave Address Translation Select #2 00000000 Works the same as Slave
Address Translation Select #1.
Default is 0.
Slave Control #2 0000 Defines the access restriction for
the address space defined with
this slave address decoder.
Default is $0000.
Master Enable #1 [Y/N] Y Yes, set up and enable the Master
Address Decoder #1.
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options Default Meaning of Default