user manual

Using the 162Bug Debugger
4-20 MVME162 Embedded Controller Installation Guide
4
The 162Bug Debugger Command Set
The 162Bug debugger commands are summarized in Table 4-3. The command
syntax is shown using the symbols explained earlier in this chapter. The
CNFG and ENV commands are explained in Appendix A. Controllers,
devices, and their LUNs are listed in Appendix B or Appendix C. All other
command details are explained in the MVME162Bug Debugging Package User’s
Manual.
Table 4-3. Debugger Commands
Command
Mnemonic Title
Command Line
Syntax
AB Automatic Bootstrap
Operating System
AB [;V]
NOAB No Autoboot NOAB
AS One Line Assembler AS ADDR
BC Block of Memory Compare BC RANGE DEL ADDR [; B|W|L]
BF Block of Memory Fill BF RANGE DEL data [DEL increment] [; B|W|L]
BH Bootstrap Operating
System and Halt
BH [DEL Controller LUN][DEL Device LUN][DEL String]
BI Block of Memory Initialize BI RANGE [;B|W|L]
BM Block of Memory Move BM RANGE DEL ADDR [; B|W|L]
BO Bootstrap Operating System BO [DEL Controller LUN][DEL Device LUN][DEL String]
BR Breakpoint Insert BR [ADDR[:COUNT]]
NOBR Breakpoint Delete NOBR [ADDR]
BS Block of Memory Search BS RANGE DEL TEXT [;B|W|L]
or BS RANGE DEL data [DEL mask] [;B|W|L [,N][,V]]
BV Block of Memory Verify BV RANGE DEL data [increment] [;B|W|L]
CM Concurrent Mode CM [[PORT][DEL ID-STRING][DEL BAUD]
[DEL PHONE-NUMBER]]|[;A]|[;H]
NOCM No Concurrent Mode NOCM
CNFG Configure Board
Information Block
CNFG [;[I][M]]
CS Checksum CS RANGE [;B|W|L]
DC Data Conversion DC EXP | ADDR [;[B][O][A]]
DMA DMA Block of Memory Move DMA RANGE DEL ADDR DEL VDIR DEL AM
DEL BLK [;B|W|L]
DS One Line Disassembler DS ADDR [:COUNT | DEL ADDR]
DU Dump S-records DU [PORT]DEL RANGE [DEL TEXT][DEL ADDR]
[DEL OFFSET][;B|W|L]
ECHO Echo String ECHO [PORT]DEL{hexadecimal number} {’string’}
ENV Set Environment to
Bug/Operating System
ENV [;[D]]
GD Go Direct (Ignore Breakpoints) GD [ADDR]