User Guide Communications Gateway

19 Communications Gateway User Guide
Cabling and Startup for a Single User, continued
Introduction Before You Begin Installation & Configuration FAQ
Troubleshooting
Glossary
License
X
Home Print Exit
19 To connect the telephone line(s), plug a telephone wire into one or both phone jacks.
Caution
20
To connect to the Internet, connect your computer to the Communications Gateway
using USB or Ethernet:
USB: Be sure the Motorola Communications Gateway CD-ROM is inserted in your
CD-ROM drive. Connect the USB cable to the USB port on the Communications
Gateway. Connect the other end to the USB port on your computer. Then perform
“Setting Up a USB Driver” on page 21.
Ethernet: Connect the Ethernet cable to the Ethernet connector on the
Communications Gateway. Connect the other end to the Ethernet port on your
computer. Ethernet users do not need to set up a USB driver.
If you connect to a wired telephone wall jack, be sure it is not connected to
a traditional telephone (PSTN) service.
P/N: 4762 03 -00 1 Made in Taiwan, R.O.C.
CM H FC MAC ID : A B CDE F 01 23 45
CUSTOMER S/N: BCDEFGHJKLMNP
S/N: PPPPMMYYJJ JSSSSSCKAABBCCCC
MT A MAC ID: A BC DEF01 23 45
Caution
Do not connect both the Ethernet
and USB cables to the same
computer.
To power outlet
To cable outlet
To Ethernet or USB
(connect only one to a
single computer)
To telephone lines