User Guide Communications Gateway

14 Communications Gateway User Guide

Cabling and Startup for a Single User, continued

Introduction Before You Begin Installation & Configuration FAQ

Troubleshooting

Glossary

License

Home Print Exit

6 On the battery compartment cover, push in on the tabs, as shown by arrows 1 in the

illustration at top left.

7 Carefully remove the battery compartment cover by lifting up about 2 to 3 cm (1 inch)

and then pulling straight out. To avoid damaging the cover, be sure you rotate it only

slightly (arrow 2) before pulling it out (arrow 3).

For a description of the battery compartment, see “Battery Compartment” on page 6.

8 As shown at lower left, depress both battery snaps (arrows 1) while gently raising the

positive end of the battery (arrow 2).

9 When the battery rotates past the snaps, slide the battery out as shown below.

Be sure you do not damage the battery wires or terminals.

Battery snaps

Battery hook