Specifications

February 23, 2000 Motorola Personal Communications Sector Page 45
Satellite Subscriber Products Division
Motorola Personal Communications Sector
Satellite Subscriber Products Division
ISU AT Command Reference Extended Wireless Commands (+W)
<mi> denotes the measurement interval and can take the following values: 1-255 (in 1000-ms unit).
Default is 15 for 15000 ms.
<dtl> denotes the delay tolerance in the link delay difference and can take the following values:
1-100 (in 1% unit). Default is 10%.
Read Command: +WDLDM?
Query the current parameter settings. The response is in the form:
+WDLDM: <dldm>,<mi>,<dtl>
Test Command: +WDLDM=?
List the supported parameter settings. The response is in the form:
+WDLDM: (supported <dldm>s), (supported <mi>s),(supported
<dtl>s)
8.5 +WDAV - Set DAV Device
Set Command: +WDAV=<client>[,<encryption>]
Set the DAV (Data After Voice) device type connected to the ISU. The type of DAV device registered deter-
mines how voice and data calls are handled.
<client> can take the following values:
0 No DAV device is registered. This means only standard data calls are setup. No DAV
connection are going to be established (default).
1 A type 1 DAV peripheral is registered. Type 1 devices can setup a standard
point-to-point data call. When a type 1 device is registered, the ISU shall initiate a voice
call and on answer, negotiate a DAV data connection. Both mobile originated and net-
work initiated calls are accepted.
2 A type 2 DAV peripheral is registered. Type 2 devices can only setup a mobile origi-
nated data connection to an Internet Protocol (IP) server that is directly attached to the
switch in an Iridium gateway. When a call is initiated, a DAV call is already assumed.
Network initiated DAV and standard data calls are rejected.
<encryption> can take the following values:
0 No encryption (default).
Read Command: +WDAV?
Query the current parameter setting. The response is in the form:
+WDAV: <client>,<encryption>
Test Command: +WDAV=?
List the supported parameter settings. The response is in the form:
+WDAV: (supported <client>s), (supported <encryption>s)