Specifications

February 23, 2000 Motorola Personal Communications Sector Page 35

Satellite Subscriber Products Division

Motorola Personal Communications Sector

Satellite Subscriber Products Division

ISU AT Command Reference Extended Cellular Commands (+C)

List the supported volume level settings. The response is in the form:

+CLVL: (supported <level>s)

4.41 +CMER - Mobile Equipment Event Reporting

Set Command: +CMER=[<mode>[,<keyp>[,<disp> [,<ind>[,<bfr>]]]]]

Enables or disables sending of unsolicited result codes from ISU to DTE in the case of key presses, display

changes, and indicator state changes. <mode> controls the processing of unsolicited result codes speciﬁed

within this command. <bfr> controls the effect on buffered codes when <mode> 1, 2 or 3 is entered. If set-

ting is not supported by the ISU, +CME ERROR: <err> is returned. The deﬁned values for the parameters

are as follows:

<mode>:

0 buffer unsolicited indications in the ISU; if the buffer is full, the oldest indications are

discarded

1 discard unsolicited indications when ISU-DTE link is reserved (e.g. in on-line data

mode); otherwise forward them directly to the DTE

2 buffer unsolicited result codes in the ISU when ISU-DTE link is reserved (e.g. in

on-line data mode) and ﬂush them to the DTE after reservation; otherwise forward them

directly to the DTE.

<keyp>:

0 no keypad event reporting

1 keypad event reporting using result code +CKEV: <key>,<press>. <key> indicates the

key and <press> if the key is pressed or released (1 for press and 0 for release).

NOTE: When this mode is enabled, corresponding result codes of all keys currently pressed are ﬂushed

regardless of <bfr> setting.

2 keypad event reporting using result code +CKEV: <key>,<press>. All key pressings are

directed from ISU to DTE.

NOTE: When this mode is enabled, corresponding result codes of all keys currently pressed are ﬂushed

regardless of <bfr> setting.

<disp>:

0 no display event reporting

1 display event reporting using result code +CDEV: <elem>,<text>. <elem> indicates the

element order number and <text> is the new value of text element. Character set used in

<text> is as speciﬁed by command Select TE Character Set +CSCS

2 display event reporting using result code +CDEV: <elem>,<text>. All display events are

directed from ISU to DTE. Character set used in <text> is as speciﬁed by command

Select TE Character Set +CSCS

<ind>:

0 no indicator event reporting

1 indicator event reporting using result code +CIEV: <ind>,<value>. <ind> indicates the

indicator order number and <value> is the new value of indicator.

2 indicator event reporting using result code +CIEV: <ind>,<value>. All indicator events

are directed from ISU to DTE.

<bfr>: