Specifications

February 23, 2000 Motorola Personal Communications Sector Page 14
Satellite Subscriber Products Division
Motorola Personal Communications Sector
Satellite Subscriber Products Division
ISU AT Command Reference Basic AT Commands
No action, compatibility only.
3.45 \Jn - DTE Auto Rate
Enable DTE auto rate adjustment
No action, compatibility only.
3.46 \Kn - Control Break
Control the response of the ISU to a break received from the DTE or the remote modem according to the
parameter specified. The response is different in three separate states:
When a break is received from DTE when ISU is in data transfer mode:
0 Enter on-line command mode, no break sent to remote modem
1 Clear data buffers and send break to remote modem
2 Same as 0
3 Send break to remote modem immediately
4 Same as 0
5 Send break to remote modem in sequence with transmitted data (default)
When a break is received from the remote modem during a non-error corrected connection:
0 Clear data buffers and send break to DTE
1 Same as 0
2 Send break to DTE immediately
3 Same as 2
4 Send break to DTE in sequence with received data
5 Same as 4 (default)
3.47 \Nn - Link Type
Define the link type to be used.
No action, compatibility only.
3.48 \S - Show Status
Show the status of the commands and S-Registers in effect.
3.49 %Cn - Compression Control
Enable/disable data compression. Data compression can only be performed on an error corrected link (i.e.,
acknowledged mode).
No action, compatibility only. Use the +DS command to set data compression.
3.50 %En - Auto Retrain