Manualshelf

Specifications

ManualsBrandsMotorola ManualsHeadphonesCommand One
11121314151617181920
February 23, 2000 Motorola Personal Communications Sector Page 13
Satellite Subscriber Products Division
Motorola Personal Communications Sector
Satellite Subscriber Products Division
ISU AT Command Reference Basic AT Commands
1 Same as 0.
3.37 &V - View Active and Stored Configuration
View the current active configuration and stored profiles.
3.38 &Wn - Store Active Configuration
Store the active profile in non-volatile memory. This is used to store user configurations for later use.
0 Store current (active) configuration as profile 0.
1 Store current (active) configuration as profile 1.
3.39 &Xn - Select Synchronous Clock
Select the source of the transmit clock for synchronous mode of operation.
No action, compatibility only.
Any value for n is accepted.
3.40 &Yn - Designate Default Reset Profile
Select profile for use after reset or power-up.
0 Select profile 0 (default).
1 Select profile 1.
3.41 &Zn=x - Store Telephone Number
Store a telephone number x in location n. n = 0-3, x is up to 36 digits and can include all the dial modifiers
described in the ATD section. To dial the number use the ATDS=n command.
No action, compatibility only.
3.42 \An - MNP Block Size
Select maximum MNP block size.
No action, compatibility only.
3.43 \Bn - Transmit Break
Transmit break to remote. In non-error correction mode, the ISU will transmit a break signal to the remote
modem with a length in multiples of 100 ms according to the parameter specified. Values for n is 1-9.
No action, compatibility only.
3.44 \Gn - XON/XOFF Flow Control
Set the use of XON/XOFF flow control in normal mode.