Specifications

75
A
38-pin Mictor Connector
(AMCC 405 and 440
Processors)
A.1 38-Pin Mictor Connector Specifications 75
A.2 AMCC 405 and 440 Timing Specifications 78
A.1 38-Pin Mictor Connector Specifications
The recommended manufacturer’s part number for this 38-pin Mictor connector is
part number AMP 2-767004-2.
This connector’s pin-out information for the AMCC 405 processor is shown in
Figure A-1. The pin-out information for the AMCC 440 processor is shown in
Figure A-2.
No terminations are required for any of the trace signal pins. For JTAG
terminations, the following table contains the Wind River-recommended
pull-up/pull-down resistor values that must be placed on the target. Signals not
shown should not have pull-ups or pull-downs.
Ta ble A - 1 16-pin Connector JTAG Terminations
Signal Name Description
TRST External 4.7K pull-up