Specifications

4 Filtering Trace

4.3 Filtered Trace Limitations

Trace Sync Broadcast

This is an internal Wind River option.

Trace Trigger

This option is similar to Trace Off. The only difference is that once it hits the trigger

and stops tracing, the trace will remain stopped until the next

GO command is

issued. Use the Post Trigger Counter to control the amount of trace captured after

the address match.

This option can also be set using low-level commands. At the

>BKM> prompt in

the OCD Command Shell, use the following commands:

Syntax:

IHBC addr TRIG

Set PT value

IHBD addr data TRIG

Set PT value

value -- limit is FFFF.

4.3 Filtered Trace Limitations

4.3.1 Filtered Trace Limitations For Wind River Trace With AMCC 405 and 440

Processors

The filtered trace options that are supported with the AMCC 405 and 440

processors are as follows:

■

One Trace On (TE)

■

One Trace Off (TD)

■

One Trace On (TE) and one Trace Off (TD)

■

One To Four Report Only (MK)