Specifications

4 Filtering Trace
4.2 Filtered Trace Options
65
4
PID Changes
Display a marker in the Events field whenever the Process ID (PID) of the running
process changes.
Report Only
This option will tell the processor to output a special trigger pattern, which will be
captured, stored in the trace buffer, and reported as a matched “of” address. This
option is only valid with the instruction code breakpoint.
This option can also be set using low-level commands. At the
>BKM> prompt in
the OCD Command Shell, use the following commands:
Syntax:
IHBC addr MRK
Trace Around
Toggles trace on at the matched address, and immediately toggle trace off again. It
will capture only the matched address. This option is useful for measuring the
timestamp for a specific routine. Use the After Trace Counter to control the amount
of trace captured after the address match.
This option can also be set using low-level commands. At the
>BKM> prompt in
the OCD Command Shell, use the following commands:
Syntax:
IHBC addr TC
Set AT value
or
IHBD addr data TC
Set AT value
value = limit is FFFF.
Trace Mark
Place a trace marker on a specified address.