Specifications

2 Hardware Setup
2.4 Wind River Trace with Wind River ICE SX
11
2
Wind River ICE SX connects to Wind River Trace via a 51-pin extension cable.
If you order the Wind River Trace as a separate product, it will have to be attached
to your Wind River ICE SX before use.
To connect the Wind River Trace to the Wind River ICE SX, use the following steps:
1. Remove the personality module from the Wind River ICE SX.
On the underside of the target end of the 51-pin cable, you will see a small
rectangular cover that clips the personality module into place.
2. Pry the module out of its position by gently pushing a small screwdriver into
the open grooves located on the sides of the cover, as shown in Figure 2-2.
Figure 2-1 Wind River Trace with Wind River ICE SX
!
CAUTION: Wind River recommends that you return your Wind River ICE SX to a
Wind River service representative to have the Wind River Trace unit attached to it.
!
CAUTION: Before attempting to remove the personality module on the ICE
unit, make sure that the power on the ICE unit is
OFF, and that it is
disconnected from its power supply.