Specifications

Wind River Trace for Wind River Workbench

Hardware Reference, 3.0

The trace signals are high-speed signals, so be extremely careful when connecting

these signals from the ColdFire processor to the trace interface BDM connector.

Some ColdFire trace signals are multiplexed pins that can be configured as trace

signals or as GPIO signals.

2.4 Wind River Trace with Wind River ICE SX

The Wind River Trace unit is shipped already connected to the Wind River ICE SX

unit, as shown in Figure 2-1.

MCF5207, MCF5208, MCF5211,

MCF5212, MCF5213, MCF5214,

MCF5216, MCF5232, MCF5233,

MCF5234, MCF5235, MCF5270,

MCF5271, MCF5274, MCF5274L,

MCF5275, MCF5275L, MCF5280,

MCF5281, MCF5282

PST0, PST1, PST2, PST3, DDATA0, DDATA1,

DDATA2, DDATA3, CLKOUT, VCC_CPU, GND

MCF52221, MCF52223, MCF52230,

MCF52231, MCF52233, MCF52234,

MCF52235

PST0, PST1, PST2, PST3, DDATA0, DDATA1,

DDATA2, DDATA3, PSTCLK, VCC_CPU, GND

MCF5407, MCF5470, MCF5471,

MCF5472, MCF5473, MCF5474,

MCF5475, MCF5480, MCF5481,

MCF5482, MCF5483, MCF5484,

MCF5485

PSTDDATA0, PSTDDATA1, PSTDDATA2,

PSTDDATA3, PSTDDATA4, PSTDDATA5,

PSTDDATA6, PSTDDATA7, PSTCLK, VCC_CPU,

GND

Table 2-1 ColdFire Trace Signal Requirements

Processor Trace Signals

NOTE: These trace signals must not be re-configured as GPIO pins by the

application code.