Microcontroller User's Manual

29-42 MCF5282 User’s Manual MOTOROLA
Processor Status, DDATA Definition
move.w {Dy,#imm},CCR PST = 0x1
movem.l #list,<ea>x PST = 0x1, {PST = 0xB, DD = destination},...
2
movem.l <ea>y,#list PST = 0x1, {PST = 0xB, DD = source},...
2
moveq #imm,Dx PST = 0x1
muls.l <ea>y,Dx PST = 0x1, {PST = 0xB, DD = source operand}
muls.w <ea>y,Dx PST = 0x1, {PST = 0x9, DD = source operand}
mulu.l <ea>y,Dx PST = 0x1, {PST = 0xB, DD = source operand}
mulu.w <ea>y,Dx PST = 0x1, {PST = 0x9, DD = source operand}
neg.l Dx PST = 0x1
negx.l Dx PST = 0x1
nop PST = 0x1
not.l Dx PST = 0x1
or.l <ea>y,Dx PST = 0x1, {PST = 0xB, DD = source operand}
or.l Dy,<ea>x PST = 0x1, {PST = 0xB, DD = source}, {PST = 0xB, DD = destination}
ori.l #imm,Dx PST = 0x1
pea <ea>y PST = 0x1, {PST = 0xB, DD = destination operand}
pulse PST = 0x4
rems.l <ea>y,Dx:Dw PST = 0x1, {PST = 0xB, DD = source operand}
remu.l <ea>y,Dx:Dw PST = 0x1, {PST = 0xB, DD = source operand}
rts PST = 0x1, {PST = 0xB, DD = source operand},
PST = 0x5, {PST = [0x9AB], DD = target address}
scc Dx PST = 0x1
sub.l <ea>y,Rx PST = 0x1, {PST = 0xB, DD = source operand}
sub.l Dy,<ea>x PST = 0x1, {PST = 0xB, DD = source}, {PST = 0xB, DD = destination}
subi.l #imm,Dx PST = 0x1
subq.l #imm,<ea>x PST = 0x1, {PST = 0xB, DD = source}, {PST = 0xB, DD = destination}
subx.l Dy,Dx PST = 0x1
swap Dx PST = 0x1
trap #imm PST = 0x1
3
trapf PST = 0x1
tst.b <ea>x PST = 0x1, {PST = 0x8, DD = source operand}
tst.l <ea>x PST = 0x1, {PST = 0xB, DD = source operand}
tst.w <ea>x PST = 0x1, {PST = 0x9, DD = source operand}
unlk Ax PST = 0x1, {PST = 0xB, DD = destination operand}
Table 29-22. PST/DDATA Specification for User-Mode Instructions (continued)
Instruction Operand Syntax PST/DDATA