Microcontroller User's Manual

lvi MCF5282 User’s Manual MOTOROLA
Revision History
Changed pull-up indications in the ‘Internal Pull-Up’ column. Table 14-3/14-11
Change encodings for bits 31–9 to:
0 The corresponding interrupt source is masked.
1 The corresponding interrupt source is not masked.
Table 17-13/17-26
Change PIT1–PIT4 to PIT0–PIT3 throughout chapter. When a timer is
referenced individually, PIT1 should be PIT0, PIT2 should be PIT1, PIT3
should be PIT2, and PIT4 should be PIT3. Other chapters in the user’s manual
use the correct nomenclature: PIT0–PIT3.
Chapter 19
Change timeout period equation to the equation below. 19.6.3/19-7
Change UISR bits 5–3 to reserved bits Figure 23-11/23-13
Change ‘I2CR = 0xA’ to ‘I2CR = 0xA0.’ 24.6.1/24-10
Changed ‘When interfacing to 16-bit ports, the port C and D pins and PJ[5:4]
(BS
[1:0]) can be configured as general-purpose input/output (I/O)’
30.2.1/30-2
Added additional device number order information to Table 32-2 for
MCF5280 and MCF5281 at 66- and 80-MHz, and MCF5282 at 80 MHz.
Table 32-2/32-7
Delete references to ‘T
A
= T
L
to T
H
’. Chapter 33
Replace V
in
row with the row below, in which the maximum value has been
changed to 6.0 V.
Table 33-1/33-1
Replace I
DDA
row with the row below, in which the maximum value in
normal operation has been changed to 5.0 mA.
Table 33-6/33-7
Replaced Figure 33-5, “SDRAM Read Cycle” Figure 33-5/33-16
Table iii. Revision History
Revision
Number
Date of
Release
Substantive Changes Section/Page
Timeout period
PRE[3:0] (PM[15:0] 1)+2××
system clock
-----------------------------------------------------------------------------=