User Guide

English

UTILITIES

The utilities described below are programmed into

your radio by your dealer and are accessible either

via a programmable button or via the menu.

DTMF

DTMF means Dual Tone Multi Frequency and is

used when the radio is required to operate in a radio

system with an interface to telephone systems.

You can switch On or Off Permanent DTMF Mode

by using a pre-programmed DTMF button or via the

menu, please refer to “DTMF” on page 32.

Note: You must be using a keypad microphone to

perform DTMFcalls.

SCAN

You can monitor several channels in order to

receive any call that is transmitted on any of these

channels. Sixteen different channels can be

programmed into each scan list. Each channel can

share the same scan list or have different scan lists

assigned to them.

Once the radio’s scan operation is activated and the

radio detects a call coming through a channel in its

scan list, it switches to that channel for you to

receive the call.

Starting or Stopping Scan

You can start or stop a scan operation by using a

pre-programmed Scan button or via the menu,

either when the radio is in the IDLE STATE or when

in a call.

Using the Scan Button

1. Press the Scan button to start scanning. The

scan start alert tone

will sound

and the display icon G will be lit .

2. Press the Scan button again to stop scanning.

The scan stop alert tone will

sound and the display icon G is

extinguished.