Specifications

Memory Power Macintosh - 5
Power Macintosh
5300/100 LC
The Power Macintosh
5300/100 LC has no
soldered DRAM. You can
expand the amount of memory
to a total of 64 MB by
installing DRAM SIMMs.
Memory Information
DRAM Speed 80 ns
SIMM Type 72-pin
Soldered DRAM None
Number of SIMM Slots 2
Supported Sizes in MB 4, 8, 16, 32
Maximum DRAM 64 MB
Virtual Memory 1 GB
Soldered VRAM 1 MB DRAM
Number of VRAM Slots None
Note: You must remove the heat sink on the
5300 series logic board to install or replace
a SIMM in the slot next to the processor.
Note: On the back (tracing side) of the logic
board, pry off the four corner tabs of the heat
sink. Remove the heat sink from the
component side of the logic board, then install
the SIMM. Be sure to replace the heat sink
after the memory upgrade.
DRAM Configurations
Up to
64 MB
Use various sizes of 72-pin
SIMMs to expand to a total of
64 MB of DRAM.