Specifications

Memory PC/DOS Compatible Cards - 2
7-Inch 100 MHz
PC Compatibility
Card
The 7-Inch PC Compatibility
Card has no memory soldered
on to the card, but it has one
expansion slot that comes
populated with a 8 MB DRAM
DIMM. You can expand the
amount of memory to a total
of 64 MB by installing 168-
pin fast-paged mode DRAM
DIMMs.
This card comes with a 586
100 MHz processor with FPU
and 128K level 2 cache.
Virtual Memory Note: Apple recommends
you turn off Apple or third-party virtual
memory when using this card.
Memory Information
DRAM Speed 60 ns
DIMM Type 168-pin, 64-
bit-wide, 2K
refresh, fast-
paged mode
Soldered DRAM None
Number of DIMM Slots 1
Supported Sizes in MB 8, 16, 32, 64
Maximum DRAM 64 MB
Virtual Memory (See Note)
Soldered Video DRAM 1 MB
Number of Video
DRAM Slots
None
Note: To upgrade to more than 8 MB of
DRAM, you must remove the original 8 MB of
memory that comes installed on the card.
Note: This card does not have any soldered-
on memory. As this card is not capable of
sharing memory with the logic board, a DRAM
DIMM must be installed for the card to
operate.
Note: The 7-Inch PC Compatibility Card
comes with 1 MB of built-in Video DRAM. The
Video DRAM cannot be upgraded.
IMPORTANT: The 7-Inch PC Compatibility
Card does not support EDO or asymmetrical
DRAM DIMMs. DIMMs purchased from Apple
are 2K refresh rate, so you can safely use
them with the 7-Inch PC Compatibility Card.
DRAM Configurations
8 MB The 7-Inch PC Compatibility
Card has 8 MB of installed
DRAM.
Up to
64 MB
Use 8, 16, 32 or 64 MB
168-pin DIMM.